My Cart

Keep Nuts

Keep Nuts

SKU
Keep Nuts

Keep Nut Kit for holding sinks, table tops or cladding in Stone, wood, concrete or glass

Drill an 11mm hole with the supplied blind 11mm drill, blow dust out of hole insert the keep nut and tap into place with a hammer. Place penny washer over keep nut then nylon washer onto top of the penny washer then screw the thumb nut in through the washers and into the keep nut until tight

Effective dry securing system for holding sinks mechanically, quick and no resin needed.

The full Keep Nut Kit Consists of Parts 1, 2, 3, 4 & a 11mm Drill

Thread stops before end of insert, avoiding extraction as a result of the use of an excessively long bolt - Radial force is produced only while the insert is under tensile load. The crowns spread the load into the parent material, allowing large loads to be carried

Average Pull-out load on a single Keep Nut insert is approx 300Kg. Tests were carried out under laboratory conditions. Pull-out figures are indicative only and are offered for guidance purposes. It is recommended that you undertake your own tests in the actual application panel material.

Total £0.00
Grouped product items
Product variants
Code Price Stock Type Pack Qty Price Qty
Keep Nut M6 Thread (Set 100) SKU: 53.220.01
0 £377.00
Place on Back order – Stock is due in soon
TypeKeep Nut M6 Stud Pack Qty100
0 £377.00
38mm Penny Washers (Set 100) SKU: 53.220.02
0 £9.37
Place on Back order – Stock is due in soon
Type38mm Penny Washers Pack Qty100
0 £9.37
Nylon Washers (Set 100) SKU: 53.220.03
0 £8.82
Place on Back order – Stock is due in soon
TypeNylon Washers Pack Qty100
0 £8.82
Thumb Screw M6 x 10mm (Set 100) SKU: 53.220.04
0 £25.36
Place on Back order – Stock is due in soon
TypeThumb Screw M6 Pack Qty100
0 £25.36
Keep Nut Kit Consisting of Parts 1, 2, 3, 4 & an 11mm Drill SKU: 53.220.05
0 £446.00
In stock. Order by 4pm for next day delivery.
TypeKeep Nut Kit Pack Qty100
0 £446.00