Black Nest Rubber Matting
Black nest rubber matting for use on most bridge saws
Great for fabricating UCS, porcelain and ceramic products as it absorbs vibration and gives cushion.
Blade should protrude into the bed by 1.5-2mm, and the rubber bed is designed to 'part' as the blade passes rather than 'cut' making the lifetime of the bed up to 5 years.
Rubber Matting is 5mm Thickness.
Instructions for Installation;
Make sure saw bed is flat via milling or adding/replacing new wood to bed. Apply single part epoxy adhesive 53.207.01 evenly over the wooden saw bed only (do not apply to wooden bed and nest matting). Then apply the matting and smooth out using reasonable hand pressure. Following this, you should evenly pressurise with weight for a minimum of 12 hours i.e. Totally cover with a slab of stone etc.
Ideally leave to set for 24hrs. Trim matting to fit saw bed